The operator of the embossing press machine must be trained to master the equipment performance and operating technology before operating independently, so as to ensure safety.

Before the operation of the embossing press, various sundries on the mold shall be cleaned and any dirt on the hydraulic press rod shall be wiped. The hydraulic press must be installed under the condition of power failure. It is prohibited to bump the start button, handle and foot on the foot switch. Assemble the upper and lower molds for centering, adjust the mold clearance, and do not allow unilateral deviation from the center. After confirmation, press the mold again.

Before the embossing press stamp works, start the equipment to idle for 5 minutes. At the same time, check whether the oil level in the oil tank is sufficient, whether the sound of the oil pump is normal, and whether the hydraulic unit, pipes, joints, and pistons have leaks. Start the equipment for pressure test, and check whether the pressure reaches the working pressure, whether the equipment acts normally and reliably, and whether there is leakage. Adjust the working pressure, but it should not exceed 90% of the rated pressure of the equipment. Test a piece of work and produce it after passing the inspection.

For different paper embossing press profiles and workpieces, during press mounting and calibration, the working pressure of the press, the number and time of pressure application and pressure holding shall be adjusted at any time, and the die and workpieces shall not be damaged. When the pressing plate of the machine body slides up and down, it is strictly forbidden to put your hands and head into the working parts of the pressing plate and mold. It is strictly prohibited to knock, stretch, weld, cut, bend, twist and other operations while applying pressure.
No smoking, welding, cutting or hot work is allowed around the manual embossing press, and no flammable and explosive materials are allowed to be stored. After the hydraulic press is completed, cut off the power supply, wipe the hydraulic rod of the press, add lubricating oil, clean the mold and workpiece, and place them in order.